Datasheet

P1024810-101 • EN-7
6.03 in. [ 15.2. cm ]
2.00 in. [ 5.1 cm ]
10.80 in. [ 27.4 cm]
“A”
“A”
“A”
“A”
Figure 1: RW 420 Route Solutions Vehicle Cradle
Description
The Route Solutions Vehicle Cradle provides a source of power
to run and charge the RW 420 Route Solutions from the vehicle’s
electrical system. In all installations, the power cable is wired to the
vehicle’s battery power indirectly through a power take-off point.
DC power for the Route Solutions Vehicle Cradle is supplied from
the vehicle’s electrical system by one of two cable assemblies:
• The cigarette plug cable (p/n AK17463-007),
• The un-terminated power cable (p/n AK17463-006) which
must be hard-wired into the vehicle’s electrical system.
Notes: The mounting holes shown at four places “A” allow mounting to either
a surface in the vehicle, or to the optional Flexible Arm (RAM) Mount (refer to
page 13).
The orientation of the Route Solutions Vehicle Cradle as shown in Figures 1
and 2 will result in the Route Palette being mounted with its carrying handle
facing up. As a consequence, the display on the terminal and the RW 420
will be “upside down” in relation to the user. The Vehicle Cradle may be
oriented 180° from its illustrated position if the printer and terminal displays
must be read by the user when installed in the Vehicle Cradle.
THE RW 420 ROUTE SOLUTIONS VEHICLE
CRADLE AK18822-1
continued
Power Connection to
Palette
Mounting holes 4 places marked “A”
(see Notes)
10.80 in [27.4 cm]
6.03 in [15.2 cm]
“A”
“A”
“A”
“A”
DC power input
Cable
2.00 in [5.1 cm]
1.19 in [3.02 cm]
4.58 in [11.6 cm]
2.25 in [5.7 cm]
1.50 in
[3.8 cm]