Datasheet

P1024810-101 • EN-4

Special Notices

The following notices emphasize certain information in this

guide. Each serves a special purpose and is displayed in the for-

mat shown:

NOTE: Note is used to emphasize any signiﬁcant information.

Caution: Indicates information that, if not followed, can result in damage

to software, hardware, or data.

Caution: This symbol indicates a potentially hazardous situation which, if

not avoided, can result in personal injury.

Caution: This warning symbol indicates a potentially hazardous situation

which, if not avoided, may be a shock hazard.

Warning: This warning symbol indicates an imminently hazardous

situation which, if not avoided will result in death or serious injury.

Before you work on any equipment, be aware of the hazards involved with

electrical circuitry and be familiar with standard practices for preventing

accidents

Vehicle Installation Safety

Caution: Only trained and qualiﬁed personnel should be allowed to install,

replace, or service this equipment.

Caution: DO NOT USE THE RW 420 ROUTE SOLUTIONS WHILE DRIVING, as

this may result in property damage or personal injury. Zebra Technologies

Corp. does not promote the use of these products except when parked or

stationary, and is not responsible for any loss resulting from the use or

misuse of our products. Most importantly, we do not want to see harm

come to our customers or anyone else.

Caution: Do not install RW 420 Route Solutions where they will be exposed

to precipitation or excessive condensation.

Caution: Do not install RW 420 Route Solutions on or near an airbag cover

plate or within an airbag zone. Also, do not install RW 420 Route Solutions

in a location that will affect vehicle safety or operation.

Caution: The means of routing and securing the Power Input cable from the

RW 420 Route Solutions through to the vehicle power source is extremely

important. Hazards associated with improper wiring can be severe. To

avoid unintentional contact between the wire and any sharp edges,

provide the cable with proper bushings and clamping where it passes

through openings. If the wire is subjected to sharp surfaces and excess

engine vibration, the wiring harness insulation can wear away, causing a

short between the bare wire and the chassis. This can start a ﬁre.

Caution: The vehicle charging circuit must neither undercharge nor

overcharge the vehicle battery. Either fault condition in the vehicle

electrical system can cause a no-charge condition in the printer battery.