Datasheet

P1024810-101 • EN-15
Vehicle Cradle Preparation
Refer to the section on Route Solutions Vehicle Cradle prepa-
ration earlier in this section for more specific information on
securing the input power cable. Locate the Mounting Arm so
when installed with the RW 420 Route Solutions system the oper-
ator can easily load printing media, operate the printer’s controls
and perform routine maintenance such as cleaning the printhead.
Follow these guidelines:
1. Select a location in the vehicle that will avoid personal con-
tact in case of an accident.
2. Plug the input power cable into the bottom of the Cradle.
3. Be sure to leave enough slack in the power cable to allow
the Mounting Arm to pivot freely without putting strain on
the power connections.
• Make sure that the input power cable routing does not
invite damage to the cable when the Vehicle Cradle is piv-
oted.
Input Power Completion
Route the input power cable per the earlier section in this Guide:
“Input Power Cable Completion.”
Figure 6: Securing the Vehicle Cradle to the Mounting Arm
Route Solutions Vehicle
Cradle
Use #8 hardware
supplied with kit
to secure Cradle
to Mounting Arm
#10 hardware
supplied with
kit may be used
to secure to
mounting surface
Tightening Clamp
Route Solutions