Datasheet

P1024810-101 • EN-14
For ease of installation, the Arm can be disassembled by
loosening the clamp enough to remove the two ball and socket
flanged ends. These end flanges can then be easily secured to the
Route Solutions Vehicle Cradle and the desired mounting surface.
Then the arm can be slipped over the two ball ends and the clamp
tightened to secure the Cradle in position.
When installing the mounting arm, remember that it provides
a considerable range of movement for the Vehicle Cradle and
Printer. Extra clearance should be provided for this movement if it
is desired in the installation.
Mounting Hardware
Mounting hardware is supplied with the Mounting Arm Kit. The
#8-32 hardware (screws, washers and nuts) supplied with this kit
should be used to secure one end of the arm to the bottom of the
Route Solutions Vehicle Cradle at the four mounting holes marked
“A” in figure 2. The #10-24 x 3/4” Screws and associated hardware
may be used to secure the other end of the arm to the desired
mounting surface.
Figure 5: Mounting Arm Kit Dimensions
7.35”
[187 mm]
1.19” [30 mm}
1.50” [38 mm}
R .91” [23 mm}
2.43” [62 mm}