Datasheet

P1024810-101 • EN-13

Vehicle Cradle. Use the cable retention features on the

bottom of the charger and holder module to route the

power input cable’s exit from the module. Note that two

possible routings of the input power cable are available de-

pending on your installation requirements.

A 5 Ampere, 250 Volt, Type 322 fuse is integrated with the

adapter.

• Secure the vehicle cradle with #8 [4 mm] hardware where

indicated in Figure 2 at “A”. Ensure that the mounting hard-

ware will not become loose due to vibration by using lock-

ing hardware or prevailing torque fasteners.

• Some models of the RW 420 printer may have a Magnetic

Strip Card reader and a SmartCard reader installed. If

these features are to be used when the printer is installed

on the Route pallette, it must be located so that the opera-

tor will have clear access to the reader’s slots for these

cards. Refer to the RW 420 Users Guide for more informa-

tion on the use of these features.

Always refer to the Safety, Installation and Use Guide (UMAN-RW4RP-101

or UMAN-RW4P-103) included with the RW 420 Route Solutions for

complete information on the use of the RW 420 Route Solutions system.

MOUNTING ARM KIT AK18865-1

Description

The optional mounting arm is offered for use with the Route

Solutions Vehicle Cradle. This kit provides a more versatile

method of positioning the RW 420 Route Solutions system. The

mounting arm consists of an arm with a ball and socket joint at

either end, which in turn are terminated with a mounting ﬂange.

One ﬂange is secured to the Route Solutions Vehicle Cradle by the

four mounting holes provided on the bottom plate, and the other

is secured to the desired mounting surface. A clamp on the arm

locks the Cradle in the desired position.

Mounting Arm Installation

CAUTION: Mount the Route Solutions and Route Solutions Vehicle Cradle

where it will not hit the operator in case of an accident.

Warning: Do not connect the input power cable to the Route Solutions

Vehicle Cradle until the Cradle and Mounting Arm installation have been

completed.

continued