Datasheet

P1024810-101 • EN-12

1. Cut the RED wire as near the power source as practical

2. Cut the BLACK wire to length to the nearest practical chas-

sis ground.

3. Strip 1/4” (6 mm) of insulation from the BLACK wire.

4. Securely crimp a 3/8” terminal ring onto the BLACK wire.

5. Strip 1/4” (6 mm) of insulation from the RED wire.

6. Securely crimp a 3/8” terminal ring onto the RED wire.

7. Ensure that cable terminals are well connected to the cable.

8. Connect black cable ground (-) terminal to vehicle ground

location.

9. Connect red cable power (+) terminal to vehicle power

source.

Connection To Power Source With Cigarette Adapter Cable

No input power cable preparation is necessary. Plug the ciga-

rette lighter adapter into the vehicle’s cigarette lighter power

socket. The appropriate protective fuse is integrated with the

adapter.

CAUTION: Do not attempt to replace this fuse with a higher amperage fuse.

Damage to the charger and/or the printer may result.

SECURING THE POWER CABLE

Secure the Input Power every 12 inches (30 cm) with adjustable

cable clamps or nylon wire wraps. Make sure that the cable rout-

ing does not interfere with other equipment or vehicle controls.

Ensure that the cable routing protects the cable from damage dur-

ing vehicle use.

INSTALL THE VEHICLE CRADLE

Vehicle Cradle Location

Locate the Vehicle Cradle in a location that allows convenient

access to the system. Follow these guidelines:

• Allow adequate clearance for the removal and replacement

of the RW 420 Route Solutions on the Vehicle Cradle.

Refer to Figures 1 and 2 for mounting and installation di-

mensions .

• The Route Solutions Vehicle Cradle can also be mounted

via a ﬂexible arm assembly (Zebra p/n AK18865-1) This op-

tion is covered in the following section of this manual.

• Locate the Vehicle Cradle and the RW 420 Route Solutions

so that it will avoid contact with the vehicle operator in

case of an accident.

• Make sure that cable routing does not invite damage to the

cable.

• Plug the power input cable into the mating plug on the