Datasheet

P1024810-101 • EN-11
• Make sure that cable routing does not invite damage to the
cable.
• Secure the Input Power at least every 12 inches [30 cm]
throughout the cable run.
INPUT POWER CABLE INSTALLATION
Connection To Power Source With Un-Terminated Cable
You must cut the cable to length and strip the individual wire
ends of the cable. Finally, you must complete the connections
to the vehicle power source. The installer must find the nearest
practical connection point to the main battery’s voltage. It may be
possible to use internal wiring supplied in the vehicle, but only if
the wire gauge is equal to or greater than 18 AWG.
CAUTION: There must be a fuse between the vehicle’s power source and
the input power cable connection!
The capacity of the fuse between the vehicle’s power source
and the charger should not exceed 2.2A. Consult the vehicle
manufacturer or a dealer to determine the best power connection
location.
NOTE: Actual cable termination used must be compatible with the power
source. The following is only a guideline.
continued
Figure 4: Routing the RW 420 Route Solutions Vehicle
Cradle Input Power Cables
Plug DC power
input Cable into
Vehicle Cradle
where shown,
Ensure connector
locks in place.
DC power input
Cable
AK17463-006 or
AK17463-007
Note alternate
routing