Datasheet
P1024810-101 • EN-10
NOTES: 1. It is the installer’s responsibility to ensure correct wiring and
installation.
2. Zebra is not liable for damage to any equipment caused by improper
installation or wiring of the Vehicle Cradle, or damage resulting from use
of the wrong Vehicle Cradle for the intended application.
3. Do not lengthen the input power cable. Extending the cable will affect
the systems’s reliability and radio frequency interference (RFI). Do not
attach any ground wires to the Vehicle Cradle housing.
4. Use care when attaching the converter’s power cable to the power
source. The red wire attaches to the positive (+) terminal and the black
wire to the negative (-) terminal. If wired backwards, the Vehicle Cradle
and/or the Route Solutions could be rendered inoperable and will need to
be sent to an authorized service provider for repair.
CAUTION: High voltages may be present. Always disconnect the vehicle’s
primary battery before installing any Route Solutions system component.
• Completely install the input power cable before connect-
ing the unit(s).
• Route the Input Power cable from the general area where
the unit(s) will be mounted.
• Use a snap-in bushing if the Input Power cable passes
through the vehicle’s fire wall or other sheet-metal barriers.
• Ensure that cable routing does not interfere with other
equipment or vehicle controls.
• Prepare the RW 420 Printer and the Route Solutions for
use.
Refer to Figures 1 and 2 and decide where you will mount the
RW 420 Route Solutions and the Vehicle Cradle.
Always follow the Safety Guidelines at the beginning of this
manual when deciding on the location of the Vehicle Cradle and
the RW 420 Route Solutions.
CAUTION: Locate the RW 420 Route Solutions system in the vehicle so that
it will avoid contact with the operator in case of an accident.
Refer to Figures 1 and 2 for Vehicle Cradle mounting dimen-
sions. Recommended fasteners for the Mobile Charger are #8-32
[M4] bolts, flat washers and lock washers.
CAUTION: Splicing onto the input power cable is not recommended.
Voltage drops encountered across splices and other discontinuities may
reduce power to the Route Solutions to an unacceptable level.
INSTALLATION GUIDELINES
Follow the guidelines below and all other safety instructions
when installing the Input Power cables.
CAUTION: Ensure that the input power cable you are using is labeled as
appropriate for use with the vehicle’s electrical system.