Owner's manual

Approvals And Safety Summary

XIV Psion Teklogix 7530 G2 Hand-Held Computer User Manual

• If leaking electrolyte sprays into your eyes, rinse them with clean

running water, and immediately seek medical attention.

• Do not store the battery in extremely high temperatures (e.g., a

vehicle, strong direct sunlight, etc.). This may cause the battery to

overheat or ignite, and it may also reduce the performance and

service life of the battery.

• Do not use in areas where static electricity is greater than what the

manufacturer guarantees.

• Keep batteries out of reach of children.

• Always switch the unit off before changing the battery. While the

battery is being replaced, the 7530 G2 will save its current data for

at least 10 minutes.

IMPORTANT CHARGER AND AC/DC ADAPTOR SAFETY

NSTRUCTIONS

• SAVE THESE INSTRUCTIONS – This manual contains important safety

and operating instructions for battery chargers and AC/DC adaptors.

• Before using the battery charger or AC/DC adaptor, read all instructions and

cautionary markings on the (1) AC/DC adaptor, (2) battery charger, (3) bat-

tery, and (4) product using the battery.

• The mains power cord shall comply with national safety regulations of the

country where the equipment is to be sold.

• Use of an attachment not recommended or sold by the battery charger or

AC/DC adaptor manufacturer may result in fire, electric shock, or

personal injury.

• To reduce risk of damage to the electric plug and cord when unplugging the

charger or AC/DC adaptor, pull the plug rather than the cord.

• Make sure the cord is positioned so that it is not stepped on, tripped over,

or otherwise subjected to damage or stress.

• Do not operate the charger or AC/DC adaptor with a damaged cord or plug.

Replace immediately.

• Do not operate the charger or AC/DC adaptor if it has received a sharp blow,

been dropped, or otherwise damaged in any way; it should be inspected by

qualified service personnel.

• Do not disassemble the charger or AC/DC adaptor; it should be repaired by

qualified service personnel. Incorrect reassembly may result in electric shock

or fire.