Datasheet

73
61337M ZebraNet™ Internal Wireless Plus Print Server Assembly Kit
Install the New Wireless Board
5/8/08 HC100 Maintenance Manual 61311L-001 Rev. A
Install the New Wireless Board
1. See Figure 43 on page 72. Install the wireless radio board connector into J1 on the MLB.
2. See Figure 42 on page 71. Slide a spacer under the wireless board aligning it with a
mounting hole in the wireless board.
a. Insert one of the mounting screws through the mounting hole in the wireless board
and then through the spacer and the MLB.
b. Install one of the mounting nuts on the back of the MLB, but do not tighten at this
time.
c. Repeat step 2 for the other two mounting screws, spacers, and nuts.
d. Tighten the three mounting nuts.
Reinstall the MLB
1. See Figure 42 on page 71. Slide the MLB onto the rear guide post of the new main frame
assembly.
2. Align the mounting holes of the MLB with the mounting posts on the main frame
assembly.
3.
4. Reconnect the smart card reader cable to J16 on the MLB.
5. See Figure 41 on page 70. Reconnect the wireless antenna.
a. Insert the antenna bracket into the slot on the left side of the print mechanism chassis.
b. Insert the antenna cable into the antenna bracket.
c. Replace the lock washer and nut on the end of the antenna cable and tighten the nut
using an adjustable crescent wrench.
d. Screw the antenna into the end of the antenna cable connector.
Caution • When inserting self-threading screws, be careful to avoid cross-threading or
stripping the plastic holes.
Caution •
Reinstall the MLB on the main frame assembly using the four Phillips mounting screws
previously removed.