Datasheet

61337M ZebraNet™ Internal Wireless Plus Print Server Assembly Kit

Remove the Main Frame and the Main Logic Board (MLB)

5/8/08 HC100 Maintenance Manual 61311L-001 Rev. A

2. Lay the main frame assembly on its side on the antistatic mat with the MLB facing up.

3. Disconnect the smart card reader cable from J16 on the MLB.

4. See Figure 41. Disconnect the wireless antenna.

a. Unscrew the antenna from the end of the antenna cable connector.

b. Using an adjustable crescent wrench, remove the nut and lock washer from the end of

the antenna cable connector.

c. Remove the antenna cable from the antenna bracket.

d. Remove the antenna bracket from the slot on the left side of the print mechanism

chassis.

e. Discard all hardware and the antenna cable.

Note • Do not disconnect the remaining cables and ground wires from the MLB. The rest

of this procedure can be performed without removing the wires.