Datasheet

61330M Printhead Assembly Maintenance Kit

Install the New Printhead Assembly

61311L-001 Rev. A HC100 Maintenance Manual 5/8/08

Install the New Printhead Assembly

1. See Figure 8. Reconnect the right and left printhead cables.

a. Support the front edge of the socket with your fingernail.

b. Align the connector with the socket.

c. Gently pinch the connector and socket together.

d. Repeat step 1 for the other cable.

2. Thread the cable wires through the cable clip on each side of the printhead assembly.

Be sure to include the green ground wire in the cable clip on the left side of the printhead.

3. Reconnect the green ground wire.

4. Clean the print line on the printhead.

a. Use the swab from a Preventive Maintenance Kit (part number 47362) or a clean

swab dipped in a solution of isopropyl alcohol (minimum 90%) and deionized water

(maximum 10%).

b. On the underside of the printhead assembly, wipe along the brown strip from end to

end.

c. Allow the solution to evaporate.

5. See Figure 7. Align the snap tabs on the bottom of the media chute with the slots in the

printer chassis.

6. Press the back edge of the printhead assembly into the slots and then press on the metal

printhead lever plate to snap the printhead assembly into place.

Caution • Remove all jewelry that could come into contact with the printhead or other

printer parts.