Datasheet
44895L Rev. 3 3/15/04 S400/S600 Maintenance Manual Page 4-15
3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ
/XEULFDWLRQ
'LDJQRVWLFV
3ULQWHU6HOI7HVW5HVHW'HIDXOW4XLFN5HIHUHQFH&KDUW
Table 4-2 lists the self tests and default resets that can be accessed by pressing and
holding a front panel key or keys and turning the power On (l). The “X” in the four columns
on the right indicates which key or keys are pressed.
The indicates whether the self test should be performed by the operator (user) and/or
maintenance personnel. These tests produce sample labels and provide specific
information that helps the operator/maintenance personnel determine the operating
conditions for the printer. self
tests without the require special tools or knowledge and
are for repair and maintenance of the printer and only should be performed by
maintenance personnel.
Detailed information on the operator self tests are found in Section II Operations
Overview. Detailed information on maintenance personnel-only self tests immediately
follows.
Figure 4-10. Cutter Module Reinstallation
Caution:
No lubricating agents of any kind should be used on the printer! Some commercially
available lubricants will damage the finish and mechanical parts.
Mounting
Posts
Cutter
Module
Mounting
Slots