Datasheet
Page 4-14 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04
6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH
Reinstall the Cutter Module
1. Refer to Figure 4-10 on page 4-15. Position the cutter module above the cutter
mounting posts. Press down on the cutter module until the mounting slots engage
the mounting posts on the printer.
2. Refer to Figure 4-4 on page 4-10. Tighten the mounting screws in a clockwise
direction to hold the cutter module in position.
3. Position the cutter cable connector so the flat side of the connector faces away from
the printer. Insert the connector up into the mating connector on the cutter module.
4. Replace the cutter catch tray on to the two mounting slots located on the front of the
cutter module.
Test the Cutter Operation
1. If necessary, reload ribbon and media into the printer. Close the printer’s front door
and main door.
2. When the printer is turned on, the cutter module will cycle through one cutting
operation and be ready to print labels.
3. Further tests may be performed by running a Pause Key Self Test.
Figure 4-9. Reassembled Cutter Module
Note • When loading media, make sure the end of the label is positioned on top of the
platen roller, then close the printhead latch.