Datasheet
Page 4-12 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04
6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH
Cleaning the Cutter Module
1. Remove any label material that has adhered to the cutter parts and use a small
brush to remove any paper dust from the cutter module.
2. If pressure-sensitive media has been used, use a lint-free cloth soaked in an
adhesive remover to clean all gum and label residue from the cutting blades and
guards.
3. If tag stock was used, use 90% isopropyl alcohol and 10% distilled water to remove
any dirt.
Reassemble the Cutter Module
1. Refer to Figure 4-7 on page 4-13. Position the two wire springs down against the
lower cutter blade.
2. Place the rear cutter blade guard over the wire springs, perpendicular to its final
position. Place your thumbs on the top (flat) part of the guard.
3. Refer to Figure 4-8 on page 4-13. Press the rear cutter blade guard down and
forward, rotating the guard as you proceed, to lock the mounting pins into position in
the cutter side panel mounting slots. Slide the guard forward until the two wire
spring loops pop up on the backside of the guard.
Figure 4-6. Cutter Module Disassembly
Note • Ensure that the ends of the rear cutter blade guard are positioned on the
outside of the cutter side panels.
Note • Ensure that the wire springs remain positioned under the rear cutter blade
guard when assembly is completed.
Upper Cutter
Blade Guard
Rear Cutter
Blade Guard
Wire Spring Loop
Wire
Spring
Loop