Datasheet
44895L Rev. 3 3/15/04 S400/S600 Maintenance Manual Page 4-11
3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ
Disassembling the Cutter Module
1. Lay the cutter module on a table or other surface. Hold the cutter module as shown
in Figure 4-6 on page 4-12. Put your thumbs on the two wire spring loops and your
index fingers on the top of the rear cutter blade guard.
2. To remove the rear cutter blade guard, first press down simultaneously on the two
wire spring loops. While still pressing down on the wire spring loops, press the rear
cutter guard back toward you and over the top of the loops. You are trying to tuck
the wire spring loops under the cutter blade guard.
3. Continue pressing the rear cutter guard toward you and allow the back edge of the
guard to pop up as it comes free from its holders. You may now remove the rear
cutter guard by lifting it off of the module.
4. Observe the ends of the rear cutter blade guard and note the small metal pins
protruding toward the inside. During the reassembly procedure, these pins will be
mounted into the corresponding mounting slots in the cutter side panels.
5. To provide complete access to the area to be cleaned, raise the upper cutter blade
guard as shown in Figure 4-6 on page 4-12.
Figure 4-5. Cutter Module Removal
Note • The wire springs may flip up out of position during this process. They will be
repositioned during reassembly.
Mounting
Posts
Cutter
Module
Mounting
Slots