Datasheet

44895L Rev. 3 3/15/04 S400/S600 Maintenance Manual Page 4-9
3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ
&OHDQLQJWKH&XWWHU0RGXOH
The cutter module is an option available on the S400/S600 that requires periodic cleaning
to remove paper dust and gummed label residue. The following procedure should be
performed, as scheduled in Table 4-1, by the operator. However, depending on the
application and media type, it may be necessary to clean the cutter more or less often.
Remove the cutter module from the printer.
1. Turn the printer’s AC power Off (O).
2. Refer to Figure 4-3 on page 4-10. Remove the cutter catch tray by lifting it up and
away from the front of the cutter module.
3. Refer to Figure 4-1 on page 4-8. Raise the main door and lower the front door.
4. Refer to Figure 4-4 on page 4-10. Gently pull straight down on the cutter cable
connector to remove it from the cutter module.
5. Turn the cutter mounting screw in a counterclockwise direction until it is loose.
6. Hold the cutter module as shown in Figure 4-5 on page 4-11. Apply gentle upward
pressure to the left and right ends while raising the cutter module up and away from
the mounting posts. If necessary, rock the cutter module side to side to loosen it.
Figure 4-2. Printhead Cleaning
Note • In figures shown, media, and ribbon have been removed for clarity. It is not
necessary to remove the media or ribbon prior to performing the maintenance
procedures described.
Caution:
Do not exchange cutter modules between different printers. The cutter module
adjustment are optimized during installation to work with a particular printer, and may not
perform correctly if placed on a different printer.