Datasheet
Page 4-8 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04
6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH
3ULQWKHDGDQG3ODWHQ5ROOHU&OHDQLQJ3URFHGXUH
1. Refer to Figure 4-1. Open the main door and front door.
2. Open the printhead by turning the locking lever counterclockwise.
3. Remove the media and ribbon if present.
4. Refer to Figure 4-2 on page 4-9. Use a cleaning swab to wipe the print elements
from end to end. Allow a few seconds for the solution to evaporate.
5. Rotate the platen roller and clean thoroughly with a cleaning swab.
6. Brush or vacuum any accumulated paper, lint, and dust away from all of the rollers
and the media and ribbon sensors.
7. Reload the ribbon and/or media. Close and latch the printhead. Close the main and
front doors, and restore power (if previously turned off).
8. Run the Pause Key Self Test to check print quality.
Figure 4-1. Main Door and Front Door
Main Door
Front Door
Tab
2
1