Datasheet

Page 4-2 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04
6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH
(48,30(176$)(7<7,36
After reviewing each procedure, place a check in the box.
o The AC power plug and IEC 320 connectors on all Zebra Printers must bear
the certification mark of at least one international safety organization listed
below.
o Unless indicated otherwise, turn the power Off (O) before performing any
maintenance procedures to the printer.
o To prevent damage to the spindles, do not lubricate the S400™ and S600™
printer spindle assemblies.
o To prolong printhead life, when reinstalling the printhead, secure the
grounding strap to the printhead mounting screw.
o Zebra printers comply with international regulations governing radiated
emissions when using fully shielded data cables. Data cables must be fully
shielded and fitted with metal or metalized connector shells. Required
shielded data cables and connectors prevent radiation and reception of
electrical noise. Use of unshielded data cables may increase radiated
emissions above the regulated limits.
+
R