Datasheet
Page 2-28 S400/S600 Maintenance Manual 44895L Rev. 3 3/12/04
6HFWLRQ 2SHUDWLRQV2YHUYLHZ
7RSRI/DEHO3RVLWLRQ$GMXVWPHQW
This procedure positions the printing on the label relative to the top edge of the label.
Adjust if the printing is too close or too far away from the top or bottom edge of the label.
1. Press MODE twice briefly and then press and hold it for approximately five seconds
(until the pause, darken, and calibrate LEDs turn on).
2. Press FEED (V) to move the printing closer to the top edge or CANCEL (W) to
move away from the top edge. Each press of either of these keys equals eight dot
rows, or approximately 0.0394 in.
3. Press MODE twice. The mode LEDs will flash to indicate that the settings have
been saved to memory.
4. Press PAUSE to exit the Pause Mode and turn off the pause LED.
The printed configuration label on the left has a LABEL TOP line value of –084 and the
printing is closer to the top of the label (approximately 15/32 in. (11 mm) from its original
position).
Example • In Figure 2-16, the configuration label printed on the right was printed first.
It was decided to move the print closer to the top edge (in the “–” direction)
approximately 15/32 in. (11 mm).
Notice that the label top line (of the configuration label on the right) has a value of
+012.
Divided 15/32 in. (11 mm) by 0.0394 in. (.925 mm) = 11.89 (round to 12). Press
CANCEL (W) 12 times (completing the adjustment procedures) will give us the
configuration label shown on the left when you print a new configuration label.)
Figure 2-16. Adjusting the Print of the Top of Label
Position of
Print
Label direction out or printer