Datasheet

44895L Rev. 3 3/12/04 S400/S600 Maintenance Manual Page 2-27
2SHUDWLRQV2YHUYLHZ 6HFWLRQ
7HDU2II3RVLWLRQ$GMXVWPHQW
Refer to Figure 2-15.
This procedure sets the end-of-label position relative to the tear-off plate or cutter. The
media stopping position is adjustable in increments of four dot rows at a time. The
possible adjustment range is ± 80 dot rows or a distance of 0.392 in. (10 mm) up or down
from the center. Adjust if the label is not being torn or cut at the correct position.
1. Press MODE twice. The pause and position LEDs turn on.
2. To adjust the label position, press FEED (V) to move the label forward (out of the
printer) or CANCEL (W) to move the label back (into the printer).
3. Press MODE twice. The mode LEDs flash to indicate that the settings have been
saved to memory.
4. Press PAUSE to exit Pause Mode and turn off the pause LED.
Figure 2-15. Tear-Off Position Adjustment
Nominal factory-set
tear line location,
usually 00.
Label Motion