Datasheet
Page 2-10 S400/S600 Maintenance Manual 44895L Rev. 3 3/12/04
6HFWLRQ 2SHUDWLRQV2YHUYLHZ
5HPRYLQJWKH/LQHU
When the amount of liner wound on the liner rewind spindle reaches full capacity, the liner
rewind spindle full sensor activates, the Paper/Ribbon LED flashes, and printing pauses.
Use the following steps to remove the liner.
1. Unwind about 24 in (61 cm). of liner from the liner rewind spindle and cut it off at the
spindle.
2. Pull out the hold down hook and slide the liner off of the spindle and discard.
3. Feed the new starting edge of the liner through the mechanism and attach it to the
liner rewind spindle as described in “Peel-Off Mode Media Loading” on page 2-9.
4. While holding the media in position against the tear-off/peel-off plate, open and
close the printhead without disturbing the media position. The printer is now ready
to print more labels.
$GMXVWLQJWKH0HGLD6HQVRU
Refer to Figure 2-8. When the printer is turned On (l), it performs a self test and
configures its operating characteristics. Some of these characteristics are determined by
the position of the media sensor.
The media sensor assembly consists of two sections. The media passes between a
stationary light source and a movable light sensor. The light source is positioned below
the media, while the light sensor is above the media.
Media Sensor Adjustment for Non-Continuous Media
This type of media has some type of physical characteristic (web, notch, perforation, etc.)
that indicates the start or end of each label.
1. Turn the head-open lever counterclockwise to the OPEN position and raise the
printhead.
2. Look through the front of the print mechanism and locate the media sensor
adjustment lever.
3. Reposition the sensor until the top of the adjustment lever is in line with the notch in
the media.
4. Close the head-open lever.
Note • You do not need to turn the printer Off (O) for this procedure.