Datasheet
44895L Rev. 3 3/12/04 S400/S600 Maintenance Manual Page 2-9
2SHUDWLRQV2YHUYLHZ 6HFWLRQ
3HHO2II0RGH0HGLD/RDGLQJ
1. Turn the head-open lever counterclockwise to the OPEN position and raise the
printhead.
2. Slide the media guide and the media supply guide as far out from the printer frame
as possible.
3. Remove the hold down hook.
4. Place the media roll on the media supply hanger and thread the media through the
printhead assembly as shown in Figure 2-7.
5. From the front of the printer, pull the media through the printhead assembly until
approximately 24 in. (61 cm) of media extends out from the printer. Remove the
labels from the liner.
6. Thread the liner behind the lower label available sensor through the slot under the
rewind power roller and below the lower guide rod to the liner rewind spindle.
7. Wind the liner counterclockwise three or four times around the liner rewind spindle.
Ensure the edge of the liner material is against the round plate at the far end of the
spindle.
8. Place the hold down hook over the liner and insert both ends into the small slots in
the round plate at the far end of the spindle. Rotate the liner rewind spindle
counterclockwise to remove any slack in the liner.
9. Adjust the media supply guide inward until it is just touching the outer side of the
media supply roll. Lock the guide in place with the locking screw.
10. Adjust the outer edge guides on the lower guide rod and the platen guide rod until
they just touch the outer edge of the media and liner without causing the material to
buckle.
11. Adjust the media guide until it just touches the outer edge of the media and liner
without causing the material to buckle.
12. Close the head-open lever.
13. Refer to “Adjusting the Media Sensor” on page 2-10 and perform the media sensor
position adjustment.