Datasheet

Page 2-6 S400/S600 Maintenance Manual 44895L Rev. 3 3/12/04
6HFWLRQ 2SHUDWLRQV2YHUYLHZ
0HGLD /RDGLQJ
7HDU2II0RGH0HGLD/RDGLQJ
1. Turn the head-open lever counterclockwise to the OPEN position and raise the
printhead.
2. Slide the media guide and the media supply guide as far out from the printer frame
as possible.
3. Roll Media — place the media roll on the media supply hanger and thread the
media through the printhead assembly as shown in Figure 2-4.
4. Fanfold Media — feed fanfold media through either the bottom or rear access slot
of the printer as shown in Figure 2-5.
5. Adjust the media supply guide and media guide against the outer edge of the
media.
6. Close the head-open lever.
7. Perform the media sensor position adjustment.
&XWWHU0RGH0HGLD/RDGLQJ
1. Turn the head-open lever counterclockwise to the OPEN position and raise the
printhead.
2. Slide the media guide and the media supply guide as far out from the printer frame
as possible.
3. Place the media roll on the media supply hanger and thread the media through the
printhead assembly as shown in Figure 2-6.
4. Adjust the media supply guide and media guide against the outer edge of the
media.
5. With the end of the media positioned directly on top of the platen roller, close the
head-open lever. The printer automatically feeds out and cuts one label when power
is turned On (l).
6. Perform the media sensor position adjustment.
Note • Media widths and thickness vary between applications. To maintain print quality
from one application to another, refer to “Configuration Mode” on page 2-23.
Note • These guides must not cause pressure or excessive drag on the media.
Note • The end of the media must be positioned on top of the platen roller.
Note • These guides must not cause pressure or excessive drag on the media.