Datasheet
44895L Rev. 3 3/12/04 S400/S600 Maintenance Manual Page 2-3
2SHUDWLRQV2YHUYLHZ 6HFWLRQ
2SHUDWRU&RQWUROV
3DXVH.H\
Allows the operator to interrupt the printing of a batch of labels.
If Pause is pressed during printing, printing stops after completing the label being printed.
If the printer is not printing, no printing can occur.
)HHGV.H\
Forces the printer to feed one blank label.
• If FEED is pressed during printing, a blank label feeds after the current batch of
labels is completed.
• If the printer is not printing, a blank label feeds immediately.
&DQFHOW.H\
When in Pause Mode, this key cancels print jobs.
• If there are no print jobs in queue, pressing CANCEL cancels the next print job to
be sent to the printer.
• If there is one print job in the queue, pressing CANCEL once cancels the current
print job.
• If there is more than one print job in the queue, pressing and holding CANCEL for
several seconds cancels all print jobs in memory.
0RGH.H\
MODE puts the printer in Configuration Mode (for more information see “Configuration
Mode” on page 2-23) and activates the automatic media calibration procedure.
3RZHU212))6ZLWFK
Refer to Figure 2-2. On the left side of the printer, near the AC power cord, is the power
On/Off switch. Turn the power Off (O) before connecting or disconnecting any cables.
Turning the switch On (l) activates the printer and it performs a Power-On Self Test as it
begins operation. Turning the printer power On (l) while holding down certain front panel
keys launches additional printer self tests immediately following the Power-On Self Test.
These tests are described later in this section.
External influences such as lightning storms or unwanted noise on the power or data
cables may cause erratic printer behavior. Turning the AC power Off (O) and back On (l)
may reestablish proper printer operation.