Datasheet
44895L Rev. 3 3/12/04 S400/S600 Maintenance Manual Page 2-1
2SHUDWLRQV2YHUYLHZ 6HFWLRQ
6HFWLRQ
2SHUDWLRQV2YHUYLHZ
This section contains information and adjustments for becoming acquainted with,
adjusting, testing, and operating the printer. This information is also found in the User’s
Guide.
2SHUDWRU,QGLFDWRUV
Refer to Figure 2-1.
3RZHU6WDWXV,QGLFDWRUJUHHQ
3ULQWKHDG6WDWXV,QGLFDWRU\HOORZ
3DSHU5LEERQ6WDWXV,QGLFDWRU\HOORZ
3DXVH6WDWXV,QGLFDWRU\HOORZ
'DWD6WDWXV,QGLFDWRUJUHHQ
Refer to Figure 2-2. Controlled by the power on/off (l/O) switch located on the left side
near the AC power cord.
On Primary power is applied to the printer.
Off Printer has been turned off or is not receiving power.
On
A printhead over-temperature condition exists. Printing stops until the
printhead cools, then printing resumes automatically.
A printhead under-temperature condition exists. Printing continues.
Off Normal condition.
Flashing The printhead is open.
On Media is out.
Off Normal condition. Media and ribbon (if used) are properly loaded.
Flashing
Direct Thermal Mode — Ribbon is in printer.
Thermal Transfer Mode — Ribbon is out.
Peel-Off Mode — Liner rewind spindle full.
On Printer has stopped all printing operations.
Off Normal condition.
On
Data processing or printing is taking place, but no data is being
received.
Off No data is being received or processed.
Single Flash
CANCEL was pressed and a format was successfully deleted from
the print queue.
Flashing Data is being received.
Slow Flashing The printer sent a “stop transmitting” command to the host computer.