Datasheet

44895L Rev. 3 3/12/04 S400/S600 Maintenance Manual Page 1-9
'HVFULSWLRQRI(TXLSPHQW 6HFWLRQ
&RPPXQLFDWLRQ6SHFLILFDWLRQV
6HULDO'DWD&RPPXQLFDWLRQ,QWHUIDFH2YHUYLHZ
The S400 and S600 printers have a single Data Terminal Equipment (DTE) port that supports
RS-232 serial data communications. The RS-232 interface has a 9-pin DB-9S connector
located at the rear of the printer.
For all RS-232 data and control input and output signals, the S400 and S600 printers follow
both the Electronic Industries Association’s (EIA) RS-232 and the Consultative Committee for
International Telephony and Telegraphy (CCITT) V.24 specifications.
6WDQGDUG6HULDO&RPPXQLFDWLRQ&RQQHFWRU
Refer to Figure 1-2. The DTE Port is a DB-9P connector located at the rear of the printer. It
provides connection to a host via RS-232 signaling. The pinouts and signal descriptions for
the DTE port are found in Table 1-8.
Figure 1-2. Communication Cable Connections
Serial
Cable
Parallel
Cable
AC Power
Cable
AC Power
On/Off Switch
or
Communication
Interface