Datasheet
Page 1-8 S400/S600 Maintenance Manual 44895L Rev. 3 3/12/04
6HFWLRQ 'HVFULSWLRQRI(TXLSPHQW
&RPPXQLFDWLRQ,QWHUIDFHV
• Serial Port
◊ RS-232
◊ DB-9
◊ Baud Rate (110, 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800,
38400, 57600)
◊ Parity (disabled, even, odd)
◊ Stop Bits (7 or 8 data bits)
◊ Handshake (XON/XOFF or DTR/DSR)
◊ Error Detection (on or off)
◊ A null modem (crossover cable must be used to connect to a host 9-pin
connector (see Figure 1-2).
◊ A null modem cable must be used to connect to a host 25-pin connector (see
Figure 1-2).
• Parallel Port
◊ 36-pin Centronics
◊ Bi-directional port
◊ Parallel operation can be enabled or disabled in the firmware.
◊ 8-bit Parallel Data Interface supporting IEEE 1284 bi-directional “nibble
mode.”
• Ethernet
◊ Thinnet and 10BaseT connectivity are available through an external
connection to the parallel port.
◊ IPX, LAT, NetBIOS/Net BEUI, TCP/IP protocols are supported with a data
burst rate of 150 KB. HP bitronics mode is supported to provide bi-directional
high speed. SNMP - compatible and supports MIB I, MIB II, and Parallel MIB
as well as MPSPON: (Novell NetWare) PC console configuration utility IPX.