Datasheet

44895L Rev. 3 3/15/04 S400/S600 Maintenance Manual Page 4-64
3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ
10. Refer to Figure 4-55. With the memory board face up (100-pin connector to the left
and pins up), carefully slide the memory board underneath the main logic board.
11. Align the three screw holes in the main logic board with the three holes in the
connector on the memory board.
12. Finger tighten the three screws through the main logic board and the memory
board.
13. Align connector J8 at the bottom of the main logic board with the mating connector
on the power supply board.
14. Starting with the center screw, tighten all screws.
15. Press straight down on the main logic board until connector J8 has seated
completely onto the power supply board.
16. Reinstall the three screws securing the main logic board to the main frame.
17. Refer to Figure 4-53 on page 4-62. Reconnect all ribbon cable and wire harness
connectors.
Figure 4-55. Memory Board Mounting Screws
Note • Do not over-torque screws.
Main Logic Board
Mounting
Screw
Mounting
Screws
Memory Board