Datasheet
Page 4-58 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04
6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH
3RZHU6XSSO\%RDUG,QVWDOODWLRQ
1. Refer to Figure 4-51 on page 4-60. Press the power supply board onto the three
mounting snaps.
2. Reinstall the two mounting screws.
3. With the printer tilted up on the front cover, position the front hooks of the power
supply base into the holes.
4. Route the ground wire through the opening in the base.
5. Engage the rear snaps by pivoting the power supply base assembly to the printer
base.
6. Insert the screw in the middle of the media compartment that secures the main base
to power supply base together.
7. Refer to Figure 4-49 on page 4-57. Connect the ground wire to the riot (ground) bar.
8. Replace the main logic board.
9. Reconnect all ribbon cable and wire harness connectors to the main logic board.
10. Reconnect the AC power cord and perform the voltage adjustment described in
"Printhead Voltage Adjustment" on page 4-29.
11. Replace the rear cover and main door.
12. Reload media and ribbon.
13. Reconnect the data cable. Turn the printer On (l), and test for proper operation.