Datasheet

Page 4-46 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04
6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH
7. When rotated clockwise, the ribbon supply spindle subassembly encounters the
spring and attempts to spin the ribbon supply spindle subassembly
counterclockwise.
8. If the results in steps 6 and 7 are not achieved, repeat steps 2 through 7.
9. Refer to Figure 4-38. Slide the spindle assembly onto the shaft.
Figure 4-38. Spindle Assembly Installation
0.010" (0.254 mm) shim or feeler
gauge placed between
C-clip and ribbon supply
spindle subassembly
Ribbon Supply
Spindle Subassemby
Cup and Spring
Assembly
Set Screws