Datasheet

44895L Rev. 3 3/15/04 S400/S600 Maintenance Manual Page 4-37
3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ
&RQWURO3DQHO&LUFXLW%RDUG5HSODFHPHQW
1. Turn the printer Off (O), and remove the AC power cord.
2. Remove the control panel assembly.
3. Refer to Figure 4-30. Remove the control panel board from the control panel cover
by removing the two mounting screws.
4. Carefully align the replacement board over the mounting holes on the control panel
cover and reinstall the two mounting screws.
5. Remount the control panel assembly in the base guide slots and secure into the
main frame by reinstalling the mounting screw.
6. Refer to Figure 4-31 on page 4-39. Reattach the control panel ribbon cable to the
main logic board (J12).
7. Reinstall the ribbon cable strain relief to the main frame.
8. Reinstall the rear cover, and front door.
Figure 4-30. Control Panel Assembly
Control Panel
Ribbon Cable
Strain Relief
Control Panel Cover