Datasheet
Page 4-36 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04
6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH
7HDU2II3ODWH5HPRYDO
1. Open the main door.
2. Grasp the tab on top of the front door and carefully pull down until it rests on the
desktop.
3. Refer to Figure 4-29. Remove the two screws securing the tear-off plate.
4. Push up on the bottom of the tear-off plate, and pull the plate out.
5. Reverse the procedure to replace the tear-off plate.
&RQWURO3DQHO$VVHPEO\5HPRYDO
1. Turn the power Off (O), and remove the AC power cord.
2. Remove the front door.
3. Remove the rear cover.
4. Refer to Figure 4-30 on page 4-37. Remove the screw securing the control panel
assembly.
5. Remove the screw that secures the ribbon cable strain relief to the main frame.
6. Refer to Figure 4-31 on page 4-39. Detach the control panel ribbon cable from the
main logic board (J12).
7. Grasp the control panel assembly by its sides and carefully lift it out of the base
guide slots.
Figure 4-29. Tear-Off Plate
Caution:
Observe proper electrostatic safety precautions when removing, handling, and replacing
printed circuit boards.
Tear-Off
Plate
5mmHex
Screws