Datasheet

Page 4-26 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04
6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH
7DNH/DEHO6HQVRU$GMXVWPHQW
The label sensor functions only when the printer is set to Peel-Off Mode. This mode
requires that the peel-off option be installed. This sensor is not installed on printers
without the peel-off option.
Figure 4-21 shows the location of the take-label sensor. When the sensing beam is
interrupted, printing and feeding are prevented. It may accept additional label formats if
the buffer is not full. When the label is removed, the next label prints automatically.
There is no sensitivity adjustment of the take-label sensor. Sensors are attached, and
aligned at the factory when the peel-off option is installed. If a problem is encountered,
check the alignment of the sensor components. They should point directly at one another.
Also verify that the format sent contains the peel-off mode command.
Figure 4-21. Take-Label Sensor Location
Take-Label
Sensors