Specifications

Troubleshooting 6 - 3
Not a legal IP address
(1.0.0.0 - 255.255.255.255).
Cannot reach the specified IP
address.
The SNMP Host Link is not valid.
The IP address entered is
either formatted inaccurately
or cannot be accessed
(pinged).
Accurately retype the IP address, and make sure
the host device is connected and online. If this is
not successful, see
Service Information on page
xi
.
Invalid network mask. The network mask entered
is not formatted correctly.
Confirm the correct network mask from the
network administrator and enter it correctly.
Invalid SNMP version number. The version number for
SNMP protocol is not a
supported version.
Use version number 1 for SNMP version 1, and 2
for SNMP version 2c.
Invalid description. The description contained
invalid characters (<,>,or').
Correct the description.
Invalid password. The password does not
match the current user
registry (illegal characters,
too long, or too short.)
User forgot the password.
Accurately retype the password.
See
Service Information on page xi .
Name has already been used.
Serial number has already been
used.
IP address has already been used.
The name, serial number, or
IP address entered already
exists in the system.
Enter a unique value for the new name, serial
number, or IP address.
Select an item from the list. The system requires
selecting an item from the
list box before continuing.
Select an item from the list box, and then continue.
Last command is still pending. Try
again later.
The system did not finish
processing the previous
command.
Wait a few moments for the previous command to
complete before sending another command.
Another administrator is currently
logged in. Try again later.
The system does not allow
more than one administrator
to log in at a time.
Wait until the other administrator logs out (or times
out) before logging in.
Backup configuration file does not
exist.
The system cannot revert to
a backup configuration
unless a backup file exists.
Commit the new configuration to create a backup
file.
Failed to confirm the new password. The system requires
entering the password
identically two times.
Accurately retype the password twice.
Network configuration change(s)
have not been saved.
The user requested log out
prior to committing/reverting
the changes made during
the session.
Select one of the
Commit/Discard options.
Table 6-1 Troubleshooting (Continued)
Problem Possible Causes Possible Solutions