Specifications

Static IP Configuration E - 7
3. Open AdvReaderConfig.xml in any text editor.
Figure E-10 Copy AdvReaderConfig.xml
4. Change DHCP to 0, and set IPAddr, Mask, and optionally Gateway and DNS IP addresses to desired values.
5. Save the edited file locally.
6. Copy and replace the edited AdvReaderConfig.xml file in the \ReaderConfig directory.
7. Reset the reader twice as follows:
a. Insert a paper clip into the reset hole for less than two seconds, or repower the unit. The Boot LED turns
red, then remains amber during initialization. When the reader has initialized, the LED turns green.
b. After the reader initializes and the LED turns green, reset the reader again as in Step a. When the Boot
LED is green, reader is ready and accessible using the configured IP.