Service manual

Transmissive (Gap) Sensor Replacement (continued) 980357-213A
Removal of Bottom Sensor
1. Use a #0 Phillips driver to remove the
screw 3 that holds the sensor 4 to the
bottom of the cross brace
".
2. Pull the ribbon cable from its guide
posts.
Assembly of Bottom Sensor
1. Align the sensor so the ribbon cable
leads to the left.
2. Replace the screw that holds the sensor
to the cross brace and use a #0 Phillips
driver to tighten it.
3. Insert the ribbon cable into its guide
posts.
Assemble the Printer
1. Attach the carriage to the bottom frame by snapping the joints into place.
2. Replace the ribbon detent springs at the rear of the printing mechanism
3. Follow the assembly steps of the Print Mechanism Replacement procedure (980357-212).
4. Follow the assembly steps of the Media Frame Replacement procedure (980357-207).
5. Check the installation. Turn on the printer and run the AutoSense routine to get a dump
mode printout. This action tests the printer's media drive and printing capabilities.
980357-001 Rev. A 33
MOVIE