Service manual

Feed Button/LED Replacement 980357-209A

Preparations

Follow the removal steps of the Media Frame Replacement procedure (980357-207).

Removal

1. Use a slot-head screwdriver to pry the

button cover 1 from the left support

2. Lift the button 2 off the assembly.

3. Detach the ribbon cable from the

notches beneath the frame.

4. Lift the feed switch PCBA 3 out of the

recessed supports.

5. Pull the feed switch PCBA free of the

assembly.

Assembly

1. Insert the connector 4 and ribbon cable through the left support from above to below the

assembly.

2. Align the feed switch PCBA so that the LED is to the front of the assembly; then, insert the

board into its recessed supports.

3. Align the button so that the rounded end is to the front of the assembly; then, lower the button

onto the board.

4. Align the button cover so it fits over the button and LED; then, snap the cover onto the left

support.

5. Feed the ribbon cable along its path and insert it into the notches to secure it.

Assemble the Printer

Follow the assembly steps of the Media Frame Replacement procedure (980357-207).

26 980357-001 Rev. A

MOVIE