Service manual

Ribbon Supply Clutch Replacement 980357-205A
Removal
The compression spring 3 has considerable force. Hold the assembly as you begin to remove it.
1. Use retainer pliers to remove the
retaining ring : from the outside shaft
of the hub.
2. Remove the loose parts from the
assembly.
3. Remove the
E-style retaining ring 1
from the shaft of the hub ;.
4. Slide the hub ; out of the side frame
!.
Assembly
1. Insert the hub ; through the side frame
!
2. Lock the retaining ring 1 into place.
3. Place the bushing 2 on the hub shaft.
4. Place the compression spring 3 against
the bushing.
5. Place the bushing 4 against the spring
6. Mount the hole in the torsion disk 5 on
the pin on the side frame.
7. Hook the torsion spring 6 onto the tab
on the disk from beneath (the spring
must provide a counterclockwise force).
8. Hook the spring onto the mount of the
anchor disk 7. Twist the anchor disk
one-quarter clockwise revolution to put
tension on the spring.
9. Place the spacer 8 into the anchor disk.
10. Place the friction disk 9 onto the anchor disk.
11. Secure with a retaining ring :.
22 980357-001 Rev. A
MOVIE