Service manual

Ribbon Roll Hub Replacement 980357-203A
Both the front and rear assemblies are on the left side of the carriage and are replaced with the same
steps.
Preparations
Before starting the procedure, open the printer, then remove media and any ribbon from the printer.
Removal
1. Use retainer pliers to remove the E-style
retaining ring 1 from the outside of the
hub.
2. Slide the hub 4, spring 3, and washer
2 out of the carriage side frame.
Assembly
1. Align the spring so that the larger
conical end goes against the inside of
the spoked hub.
2. Place the washer so it is between the
spring and the carriage side frame.
3. Insert the hub through the bearing in
carriage side frame
!.
4. Place the E-style retaining ring to hold
the hub shaft in place.
20 980357-001 Rev. A
MOVIE