Specifications

Sample Labels
The following pages contain sample labels to be used with the preceding
troubleshooting charts. These labels illustrate conditions which could be seen if
mechanical adjustments are necessary.
Zebra Z-Trans 3P media stock and type 5319 ribbon were used to obtain these
labels. Any other label and ribbon stock combinations may produce sample labels
with similar but not necessarily the same results.
Acceptable Label:
Darkness properly set
Printhead positioned
correctly
Toggles balanced
(equal pressure on left
and right sides)
Unacceptable Label:
Darkness too high
Printhead positioned
correctly.
Toggles balanced
(equal pressure on left
and right sides)
S -Series Maintenance Manual: Volume 1 Troubleshooting
38452L Rev. 3 Page 6-5