Specifications

8. Pass the Cutter Board Power Cable along the bottom of the printer frame
toward the Main Logic Board.
9. Plug the Cutter Motor leads into the Cutter Motor Connector, J3, on the
Cutter Circuit Board. (Black lead to the left. Note: This is a “polarized”
connector.)
10. Refer to Figure 5.23. Plug the Cutter Sensor wires into the Cutter OPTO
Connector, J6, on the Cutter Circuit Board.
11. Check the installation work and insure that during operation no wiring will
touch any moving parts.
Optical Sensor Removal
1. Refer to Figure 5.22. Remove the nut that holds the Cutter Optical Sensor
Assembly (wires, Sensor Clamp, and Optical Sensor) in position.
2. Lift the Cutter Optical Sensor Assembly off the Sensor Mounting Post.
Optical Sensor Installation
1. Refer to Figure 5.22 and the Figure 5.22 inset. Install the Cutter Optical
Sensor Assembly on the Sensor Mounting Post. (The Sensor part of the
Assembly should be mounted toward the printer frame.)
2. Place the Sensor Clamp over the Optical Sensor and start the nut on the
Sensor Mounting Post. (DO NOT tighten the nut.)
3. Route the Sensor wires under the clamp and toward the rear of the printer,
and lightly tighten the nut to hold the wires in position. (DO NOT pinch
the wires.)
Lower Drive Arm Mechanical Alignment
1. Connect the Power Cable from J1 on the Cutter Board to J4 on the Printhead
Adapter Board.
Figure 5.23 Cutter Circuit Board
S -Series Maintenance Manual: Volume 1 Corrective Maintenance
38452L Rev. 3 Page 5-39