Specifications

Battery Replacement

One of the factory-installed options for the 105S printer is the Battery

Backed-Up 256 KB RAM Memory. The Battery used with this option is a 3 VDC

Lithium Coin Battery type CR2477 (Zebra Part # 44641).

CAUTION

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended.

When discarding used batteries, do not incinerate.

The battery is located on the printer’s Main Logic Board. It is recommended that

a qualified Service Technician replace this battery since internal access to the

electronics area of the printer is required.

CAUTION

Turn the printer’s AC Power Switch OFF and disconnect

the printer’s AC Power Cable before replacing the battery.

Prior to removing and replacing the battery, observe proper

electrostatic and electrical safety precautions.

To remove the old battery, gently raise the right edge and slide the battery to the

right and out of the battery holder.

Insert the new battery with the negative (−) side toward the circuit board. The

positive (+) side should be visible when the battery is correctly installed.

To use the Battery Backed-Up RAM Memory, the “Battery Dead” condition must

be reset. The preferred method of resetting this condition is to send the “~JB”

ZPL II command to the printer.

A second method for resetting the “Battery Dead” condition is available at the

printer’s front panel. However, when this method is used, the printer

configuration is reset to the Factory Default condition. The printer must then be

reconfigured for the application and a Printer Calibration must be performed. To

reset the “Battery Dead” condition using this method, press and hold the PAUSE

and FEED Keys while turning the AC Power ON.

Cutter Adjustments and Replacement Instructions (105

Only)

Printer Disassembly

The printer must be partially disassembled in order to remove and install parts.

Refer to the illustrations in this Section and follow the procedures that follow.

Corrective Maintenance

-Series Maintenance Manual: Volume 1

Page 5-34 38452L Rev. 3