Specifications

WARNING
When the printer power is turned ON in step 7, dangerous
voltage is present at the Power Supply Board.
6. Reconnect the AC Power Cord.
7. Press and hold the CANCEL Key while turning the printer AC Power
Switch ON. A Configuration Label will print.
8. Verify the “Firmware” version shown on the Configuration Label is the
same as the software just installed.
9. Complete the process by installing the Left Side Panel on the printer.
10. The printer is now ready to operate.
ZEBRA TECHNOLOGIES
CORPORATION
U14
ZEBRA TECHNOLOGIES
CORPORATION
U13
Figure 5.17 105S (6 and 8 Dots/mm) EPROM Locations
ZEBRA TECHNOLOGIES
CORPORATION
U14
ZEBRA TECHNOLOGIES
CORPORATION
U13
Figure 5.18 160S/105Se/105S (12 Dots/mm) EPROM Locations
Corrective Maintenance S -Series Maintenance Manual: Volume 1
Page 5-30 38452L Rev. 3