Specifications

Peel-Off Mode
In “Peel-Off Mode”, the Lower Roller alignment has the same effect on media
tracking as the Rewind Plate alignment does in “Rewind Mode”. Refer to
Figure 5.12 and perform the following procedure.
1.
Usea7/64″ HexAllenwrenchtoloosenthe(2)Allenscrewsthatattachthe
Platen Support Bracket to the Side Plate.
2. Moving the bracket toward the front of the machine moves the label backing
material away from the Rewind Tracking Plate. Moving the bracket toward
the rear of the machine moves the label backing toward the tracking plate.
Adjust the bracket position as required and tighten the Allen screws.
3. Print several labels and repeat steps 1 and 2 until proper tracking is
achieved.
LOWER
ROLLER
7/64" HEX
ALLEN
SCREWS
PLATEN
SUPPORT
BRACKET
Figure 5.12 Peel-Off Lower Roller Alignment
S -Series Maintenance Manual: Volume 1 Corrective Maintenance
38452L Rev. 3 Page 5-21