Specifications

Media Tracking Adjustments

Rewind Mode

If the media walks from side to side, or if it tears or wrinkles against the

Media Rewind Tracking Plate, it will be necessary to adjust the Rewind Plate

Assembly. Refer to Figures 5.10 and 5.11.

1. Remove the Rewind Plate Assembly and loosen the 5/16” Hex nuts

attaching the Hook Plate to the Rewind Plate. Moving the outer end of the

Hook Plate up will force the media towards the Rewind Tracking Plate

while moving this end down will move the media away from the Tracking

Plate. (The opposite effect will occur if the same adjustments are performed

on the inner end of the Hook Plate.)

2. Tighten the Hex nuts, reinstall the Rewind Plate Assembly, and print several

test labels. If problems persist, readjust the Hook Plate.

3. (105S and 105SeOnly)If the media cannot be made to track correctly with

the previous adjustment, check the distance from the outside of the Tracking

Plate to the Main Frame. This dimension is set at the factory and should be

0.530" (13.5 mm) to 0.570" (14.5 mm). If the distance needs to be reset,

refer to Figure 5.11 and proceed to step 4 below.

4. (105S and 105Se Only) Use a 1/16" Hex Allen Wrench to loosen the two

set screws in the Collar (located inside the Rewind Spindle Assembly). The

screws are accessible through a single hole in the Spindle Assembly, as

shown in Figure 5.11. Reposition the Spindle Assembly closer to or farther

from the Main Frame as required, and retighten the two set screws in the

collar.

5. Repeat steps 1 and 2 until the required results are achieved.

REWIND PLATE

HOOK PLATE

OUTER END

HEX NUTS

Corrective Maintenance

-Series Maintenance Manual: Volume 1

Page 5-20 38452L Rev. 3