Specifications

Take Label Sensor Alignment
The Take Label Sensor pair is active only when the S-Series printer is set to
Peel-Off mode. To operate in this mode either the Rewind Option or the Backing
Only Rewind Option must be installed. The Take Label Sensor pair
is not
included on S-Series printers unless one of these options is installed.
Refer to Figure 5.9 for the location of the Take-Label Sensor pair. When a label
printed in Peel-Off mode breaks the infrared light beam passing between the
sensors, further printing and feeding is inhibited. Additional label formats will
be accepted by the printer if the data buffer is not full. When the operator
removes the label from the sensor path, the next label will print. There is no
sensitivity adjustment for this sensor. If you encounter problems, make certain
the printer is set to Peel-Off mode and that the sensor pair are aligned. Sensors
are aligned when installed. No adjustments are required after installation.
TAKE
LABEL
SENSORS
Figure 5.9 Take Label Sensor Location
S -Series Maintenance Manual: Volume 1 Corrective Maintenance
38452L Rev. 3 Page 5-19