Specifications

7. Open the Printhead and pull the media through the printer until a label is
positioned between the upper and lower sections of the Transmissive Media
Sensor. Move the ribbon back to its normal position.
8. Close the Printhead and press the MODE key to complete the automatic
adjustment process. A Media Sensor Profile will automatically print and
the new sensor settings will be automatically saved. (See Figure 5.8)
9. Perform the Media Calibration procedure located in Getting Ready to Print.
Figure 5.8 Media Sensor Profile Sample Label
Corrective Maintenance S -Series Maintenance Manual: Volume 1
Page 5-18 38452L Rev. 3