Specifications

FEED Key Loopback Test
With the Loopback Connector in place, press the FEED Key while turning the
AC Power Switch ON.
After the POST, the printer will begin printing a series of label formats as shown
in the chart below. The printer will PAUSE at the end of each printed format.
Press the PAUSE Key to begin printing the next format. Refer to the label
examples in Figures 3.7 through 3.13.
The PAUSE Key can be used to stop and restart the printing operation. When the
printer is paused, the CANCEL Key can be used to move to the next label format.
* “C” for the 105S and 105Se with the 300 dots/inch printhead
Figure 3.7 Format 1 (8) Test Label
FORMAT PRINTING TEST FUNCTION
1 20 at Speed D* Left Ribbon Wrinkle Test
2 20 at Speed D* Right Ribbon Wrinkle Test
3 20 at Speed D* Bar Code Wrinkle Test (Code-39)
4 20 at Speed A Left Ribbon Wrinkle Test
5 20 at Speed A Right Ribbon Wrinkle Test
6 20 at Speed A Bar Code Wrinkle Test (Code-39)
7 10 at Speed D* Usable Area Test
8 10 at Speed D* Head Temp Test
9 10 at Speed D* Upper Smear Test
10 10 at Speed D* Lower Smear Test
11 10 at Speed A Usable Area Test
12 10 at Speed A Head Temp Test
13 10 at Speed A Upper Smear Test
14 10 at Speed A Lower Smear Test
Printer Diagnostics S -Series Maintenance Manual: Volume 1
Page 3-10 38452L Rev. 3