Specifications

NOTES: It is recommended that full width media be used when performing
these tests. Labels less than full width in size will lose printing on the right side.
Label length will determine the amount of printing starting at the top of the label.
When performing these self tests while in the Peel-Off Mode, the operator must
remove the labels as they become available.
When canceling a self test prior to its actual completion, always turn the printer
power OFF and then back ON to reset the printer.
Some of the printer self tests produce labels at varying print speeds. These
speeds may be referred to as “inches per second,” “millimeters per second,” or
by alphabetic letter designation (i.e., “A,” “B,” “C,” etc.). The following chart
shows the relationships between the different speeds.
* Speed “A” for the 105S and 105Se with the optional 300 dots-per-inch
printhead is 2.4" (61 mm).
Letter
Designation
Inches
per Second
Millimeters
per Second
A* 2" 51 mm
B3"76mm
C 4" 102 mm
5" 127 mm
D 6" 152 mm
Printer Diagnostics S -Series Maintenance Manual: Volume 1
Page 3-2 38452L Rev. 3